Ask an experienced operator to explain their job and you get a story. Ask them to teach it and the story turns into “watch me”. What is missing in between is the breakdown: the job on one page as important steps, key points and reasons.
Three columns, nothing else
An important step is a part of the task that moves the work forward. The test is simple: if you cannot describe the task with your steps alone, one is missing.
A key point is anything in that step that makes or breaks it. It can be safety, quality, a knack or timing. If leaving it out causes a defect, an injury or a delay, it is a key point.
The reason answers the question the learner would ask on day two. It is the column people skip, and it is the one that decides whether the key point survives the second shift.
Here is the breakdown that area A2 wrote for station S4, torque and sealing:
| Important step | Key point | Reason |
|---|---|---|
| Place the housing in the fixture | Cast mark to the front stop | The torque program finds the ports only in this position |
| Fit the seal rings | Groove dry and free of chips | A chip under the ring is the most frequent leak at the test bench |
| Set the cover | Both locating pins engaged before any bolt turns | A cross-threaded bolt scraps the housing |
| Start the torque program | Green on all six positions before you move | A missing position cannot be seen from outside |
| Mark and log the part | Stamp in the lower right field, then scan | Without the mark the part fails final inspection |
Five steps, five key points. A task that needs twenty steps is three sessions, not one sheet.
The breakdown does not replace the written work instruction at the station. The instruction is for doing the job, it is controlled and it has a version. The breakdown is for teaching it, it belongs to the trainer, and it names the version it was written against so that both move together.
Choosing the people who will teach
Being the fastest at a station is not a qualification for teaching it. A2 used four criteria.
The trainer does the work to the standard, because a trainer teaches what they do and a shortcut gets taught with everything else. They can break a task down, which is the real skill. They stay patient under pressure, because a learner who is corrected sharply stops asking and starts guessing. And they have the hours and want to do it, because nobody can be made into a trainer.
Four people volunteered, one for each station that had no trainer at level 4. That closed the trainer gap at the torque station, the leak test, the function test bench and final inspection, and it took three stations off the one person who had been teaching everything.
The trainer course is one day in the area
One day, in the area, with the real stations.
The morning covers the four steps and why each one exists, with the facilitator demonstrating on a simple task. Each participant then writes one breakdown for a task they know and presents it to the group, which is where most people discover that their key points were steps and their reasons were missing. In the afternoon each of them runs a short session with a colleague as the learner, watched by the group, and gets feedback against the four steps.
Keep the breakdowns
A2 keeps every breakdown with its station and the instruction version it was written against. When the instruction changes, the breakdown is checked within the week and the people trained on the old version get a short re-training on the new key points. A breakdown that nobody updates is how two shifts end up doing the same job differently again, which is where the area started.