Skip to content
Series | 6 parts

Measurement Systems and Gauge Management

Know every gauge, keep it calibrated and prove that the measurement fits the tolerance. 6 parts in three blocks, from the gauge list and calibration intervals to gauge selection, the repeatability and reproducibility study, attribute checks and the gauge found out of tolerance.

Every decision about a part is a decision about a number or a look. If the gauge is wrong or the measurement varies, good parts are scrapped, bad parts are shipped and nobody knows which. This series follows one worked example, the shaft line of a plant for turned and ground precision parts with 40 gauges and a bearing seat of 32.000 ±0.010 mm, through the whole sequence: how a gauge walk turns a list into the truth, how calibration intervals are set and adjusted, how two simple shares show whether a gauge fits a tolerance, how a study with ten parts, three people and three rounds splits the variation into its sources (38.6 percent of the tolerance with a micrometer by hand, 6.8 percent with a bench gauge), how visual checks are studied, and what to do when a micrometer is found 0.004 mm out of tolerance after 26 weeks and 26 lots. It covers the gauges and the measurement itself and complements the series on Six Sigma, FMEA and Control Plan, Zero Defects and Quality Tools. Limits named in the series are common practice, not requirements of a standard, and the series is not certification or legal advice.

6 parts

Newsletter

One Lean idea.
Every two weeks.