Skip to content
Measurement Systems and Gauge Management | Part 1 of 6

The Gauge List: Know What Measures Your Product

How a gauge walk, a unique number, a status label and a marked place turn a list of measuring equipment into something you can rely on.

Ask a plant how many gauges it has and you usually get the number from a list. Ask how many gauges are in the drawers of one production area and nobody knows. The difference between the two numbers is where measurement problems start.

What counts as a gauge

Everything that is used to decide whether product is good: calipers, micrometers, indicators, bore gauges, plug and thread gauges, height gauges, setting masters, torque tools and measuring machines. A tape measure used to cut packaging is not a gauge in this sense. A private caliper used to release parts is.

The example

A plant for turned and ground precision parts has 160 employees and 420 gauges. The pilot area is the shaft line: turning cell T3, grinding cell G2 and final inspection. The list for this area shows 40 gauges.

The gauge walk

The quality technician who looks after the gauges, a supervisor and one operator per shift walk the area with the printed list. They open every drawer, cabinet and toolbox. Each listed gauge that is found gets a tick. Every gauge that is not on the list goes into a red box. Label, due date and visible damage are checked on the spot.

Finding in the shaft line Gauges
On the list 40
Found and fit for use 36
Blocked: one damaged, one out of tolerance 2
Missing 2
In use with the due date passed 5
Found at workstations but not on any list 7
Label missing or not readable 3

The seven unlisted gauges were private calipers and old plug gauges. None had ever been calibrated, and all seven were removed from the area. The operators had solved a problem: the official gauge was not at hand.

One line per gauge

The list needs few fields, but each has a purpose:

  • Number: unique, engraved or laser marked on the gauge itself, never reused. Cases get lost.
  • Type, range, resolution, permissible error: needed later to match the gauge to a tolerance.
  • Location and owner: where the gauge lives and who answers for it.
  • Interval, last calibration, next due: the due date is calculated, not remembered.
  • State: in use, blocked, missing or scrapped.

Only gauges in the state “in use” may measure product.

Label and place

The status label shows the gauge number and the next due date and must be readable at the moment of use. Small gauges carry a color ring and the date on the case. Every gauge has a marked place at the workstation or in the cabinet. An empty place is a signal, in the same way as on a shadow board for tools.

The rule at the workstation is short: no label, no measurement. An operator who finds a gauge without a valid label hands it to the supervisor and takes a replacement. This rule only works with spare gauges in the cabinet. An operator without a gauge will find one in a drawer, and the red box fills again.

The dropped gauge

A drop is the most frequent cause of a gauge that reads wrong, and it leaves no trace on the label. One agreement with every operator is worth more than a procedure: a gauge that fell is handed in, checked against a setting master and returned or blocked. Handing it in is never a reason for blame.

Three numbers

After the walk, the area has its first key figures. Calibration on time is the share of gauges in use that are not overdue: 31 of 36, or 86 percent. Listed gauges found is 38 of 40, or 95 percent. The third number, unlisted gauges, should be zero and was seven.

None of this needs software. A spreadsheet that is true beats a system that is not. The next part turns to the dates in that list: how calibration intervals are set and how the workload is planned.

Newsletter

One Lean idea.
Every two weeks.