Process Capability Calculator: Cp and Cpk
How well a stable process fits into its tolerance: Cp for the spread, Cpk for spread and centering together.
Enter your figures and select Calculate. The fields are prefilled with a worked example.
How to read it
How it was calculated
Please confirm your newsletter subscription via the link in your inbox.
The formula
Use this calculator when you have measured a characteristic and want to know whether the process can hold the tolerance.
Cp = (Upper limit - Lower limit) / (6 × Standard deviation)
Cpk = min(Upper limit - Mean, Mean - Lower limit) / (3 × Standard deviation)
Worked example
Inputs
- Lower specification limit: 9.9 mm
- Upper specification limit: 10.1 mm
- Process mean: 10.02 mm
- Standard deviation: 0.02 mm
Calculation
- Cp = (10.1 - 9.9) / (6 × 0.02) = 1.67
- Upper side = (10.1 - 10.02) / (3 × 0.02) = 1.33
- Lower side = (10.02 - 9.9) / (3 × 0.02) = 2
- Cpk = smaller of the two = 1.33
Result
Cpk: 1.33. A Cpk of at least 1.33 meets the requirement many industrial customers set for important characteristics. The process is off center by 0.02 toward the upper limit: centering it would raise Cpk to the Cp of 1.67 without reducing the spread.
How to read the result
- The indices only mean something for a stable process. Check the control chart first: a capability figure from an unstable process describes the past, not the future.
- Use enough data: at least 50 values, better 100 or more, from normal production over several shifts and material lots.
- The ppm estimate assumes a normal distribution. For skewed characteristics such as flatness or roughness, the real share outside tolerance can differ clearly.
- DPMO and Sigma Level
Defects per million opportunities and the sigma level that goes with it, to compare processes of different complexity.
- First Pass Yield and Rolled Throughput Yield
The share of units that are right the first time at one step, and the share that passes a whole chain of steps without any defect.