Walk through a machining plant on a Saturday afternoon. No operator is in the hall, but the lights burn, the chip conveyors turn, the washer keeps its bath at 80 degrees Celsius and somewhere compressed air hisses from a coupling. Nobody sees it, because on weekdays everybody is busy and on weekends nobody looks.
This is the starting point of Lean and Green. Energy, material and water are resources like time and people. When they are used without creating value, they are waste.
The classic wastes in a green view
Every classic waste of Lean also consumes resources:
- Waiting: a machining center in standby with pumps and conveyors on uses energy for nothing.
- Overprocessing: a washer heated to 80 degrees where 60 degrees clean the parts just as well.
- Defects: a scrapped part loses its material and every kilowatt hour that went into it.
- Inventory: stock needs heated, lit space.
- Overproduction: energy and material for parts nobody ordered.
Lean and Green does not invent new tools. It adds energy, material and water to what you already look at.
Why now
Three things have changed. Energy has become a large cost item: in many machining plants it costs as much per part as the consumables. Larger customers ask their suppliers for CO2 per product. And depending on size and country, companies have to report energy and emissions.
What has not changed is the physics. The cheapest kilowatt hour is the one you do not use. Many plants use 15 to 30 percent of their electricity when nothing is produced.
A plant in numbers
The example in this series is a plant that machines and assembles aluminum valve blocks for hydraulic systems, two shifts on five days. It makes 600,000 good parts a year and uses 4,200 MWh of electricity and 1,800 MWh of natural gas.
That is 10.0 kWh and EUR 1.58 of energy in every block. With example emission factors it is 3.26 kg CO2e per part. On a Saturday afternoon the plant still draws 280 kW. Over a year, that is a quarter of all its electricity.
What Lean and Green is not
It is not a sustainability report written once a year. It is not buying certificates instead of using less. It is not a project of the facility manager alone, and it is not switching off machines that are needed.
It is a small set of measurements and routines that make three things visible every week: how much energy and material one good part needs, how much is used when nothing is produced, and which measure saves the most per euro.
How this series is built
The series follows the order in which a plant usually works: first see the resources, then map them and cut the obvious waste, then deal with heat, material and water, and finally decide on measures and hold the results on the shop floor board.
If you run a waste elimination program already, keep it. Lean and Green uses the same walk and the same board. It just adds a few columns.