The block layout says where the areas are. It does not say where a single machine stands, how a pallet reaches it or where the operator walks. That is the job of the detailed layout. Mistakes made here show up every shift, as a pallet in the aisle and a door that does not open fully.
From coarse to fine
The detailed layout is drawn area by area inside the borders of the chosen block layout:
- Main aisles. Position, direction and width for two-way traffic.
- Side aisles. Access to every area, one-way where possible.
- Walkways. Separate from forklift traffic, with marked crossings.
- Machines. Orientation, with the loading side toward the aisle.
- Staging areas. Marked places for incoming and outgoing loads at every machine.
- Utilities. Power, air, coolant and data at every position, from the ceiling where possible, so that the next change is cheap.
Aisles
The pump plant of this series has chosen a U-shaped block layout for its hall of 80 m by 60 m. One main aisle runs as a loop of 200 m between the three bands of areas. Side aisles of 100 m in total reach the inside of the areas.
The width of an aisle follows from the widest load, the direction of traffic and the safety distances that apply at the site. The planning values of the pump plant, for a load width of 1.2 m:
| Aisle | Calculation | Width in m |
|---|---|---|
| Main aisle, two-way | 2 x 1.2 plus three safety strips of 0.4 | 3.6 |
| Side aisle, one-way | 1.2 plus two safety strips of 0.6 | 2.4 |
| Walkway | For people only | 1.2 |
These are planning values of the example and no substitute for the workplace and fire protection rules of your country. Check every width against them before the layout is released.
The aisle area is a useful cross-check: 200 x 3.6 + 100 x 2.4 = 960 square meters, 20 percent of the 4,800 square meters of the hall. That is the aisle share the space requirement had assumed.
Machines in the area
The eight machining centers stand in two rows of four. The loading sides face a side aisle between the rows, the maintenance sides face outward. One operator can serve neighboring machines without crossing the path of a forklift.
Each machine gets two marked places for incoming pallets and two for outgoing ones.
The workstation check
Every workstation is checked against five questions before the layout is released:
- Where does material arrive and leave? From the aisle side, without the supplier entering the work zone.
- How far does the operator walk per cycle? A few steps. Material and tools within reach, heavy parts at hip height.
- Can the machine be maintained? Doors open fully, a spindle or a pump can be taken out, a lift truck can reach.
- Is the way out free? No pallet place in an escape route, no dead end longer than the rules of the site allow.
Try it at full size
A plan on a screen hides what a body notices at once. Before the layout is released, one cell is taped on the floor of a free area at full size. Pallets, carts and cardboard boxes stand in for machines and material.
The operators walk a shift in it: load a part, change a tool, bring a pallet, open the cabinet door. In the pump plant, the trial of the machining cell moved one staging area to the other side of the aisle and widened a passage by 0.4 m, because the tool cart did not pass an open door.
One afternoon on the tape finds what three weeks at the screen miss, and the people who will work in the layout have changed it before it was built.
The detailed layout is released by production, logistics, maintenance and safety together. After that, the move can be planned machine by machine.