Skip to content
Lean and Green | Part 8 of 10

Scrap, Waste and Water: The Material Side of Lean and Green

A scrapped part loses every kilowatt hour that went into it. Count scrap, separate waste streams and read the water meter like the base load.

Energy is the visible part of Lean and Green. Material is the larger one. For most machined parts the material carries more CO2e than the whole plant, and every scrapped part throws away both.

Scrap carries everything

A scrapped valve block loses its aluminum, its machining time and every kilowatt hour of sawing, machining and washing. In the example plant each block carries 3.26 kg CO2e from the plant alone.

Line 3 scrapped 3.2 percent of its 360,000 parts, mostly because of porosity in the castings found only after machining. An incoming test of the castings and a changed clamping fixture brought the rate to 1.2 percent. That saves 7,200 parts, EUR 129,600 for material and processing and 23.5 t CO2e in the plant per year, plus the material upstream.

Scrap reduction is quality work. Lean and Green adds the energy and CO2 view, which often gives the extra argument for the investment.

Waste streams

Separate, weigh and record every waste stream once a month. In the example:

  • Aluminum chips, 210 t: separated by alloy, dried and sold. Clean, dry chips are worth much more than mixed ones, often enough to pay for the chip dryer.
  • Coolant emulsion, 120 t: monitoring of concentration, filtration and tramp oil removal extend its life.
  • Mixed waste, 95 t: separation at the source, weighed per area.
  • Packaging from suppliers, 38 t: returnable containers with the two largest suppliers.

A useful figure for the board is non-recycled waste per good part. In the example it is about 0.36 kg.

Water

Water is cheap in many regions, until a dry summer or a new tariff changes that. Coolants and their disposal are expensive everywhere.

The example plant uses 14,000 m3 per year, 23.3 m3 per 1,000 parts. Coolant make-up takes 35 percent, the washer 30 percent, cooling and leak testing 20 percent and sanitary use 15 percent.

The levers are familiar: concentration control and filtration for coolants, cascade rinsing in the washer, closed cooling circuits, and bath changes by measurement instead of by calendar.

Read the water meter on Sunday night

The water meter can be read like the electricity meter. A reading on Sunday night, when nothing should flow, shows leaks the same way the base load shows idle machines.

Put water per 1,000 parts and waste per part on the monthly board. Material numbers change more slowly than energy numbers, but they add up to the largest share of the footprint.

Newsletter

One Lean idea.
Every week.