The old instruction for assembling the 63 mm cylinder at station A3 had six pages and 41 numbered sentences. It had no pictures and no reasons. It was complete, formally correct and unread. The new one fits on one sheet at A3. It has eight steps, twelve key points and eight photos.
The difference is a decision about what belongs on the sheet.
Four columns
| Element | Question it answers | Rule |
|---|---|---|
| Step | What is done to move the job forward? | One line, verb first, ten steps or fewer |
| Key point | What decides safety, quality or ease? | Three or fewer per step, with numbers and units |
| Reason | Why does the key point matter? | One sentence that names the consequence |
| Picture | What does it look like when it is right? | Operator view, this station, key point marked |
A step is not a movement. A step is a piece of the job that an operator would name: fit the piston seal, mount the covers.
A key point is not everything that could be said. If everything is a key point, nothing is. It is the little that decides whether the step is safe, whether the part is good or whether the work is easy.
Why the reason matters
A key point without a reason is skipped under time pressure. At A3 the fitting cone for the piston seal was used by three of nine operators. The others pushed the seal on with a screwdriver, which is faster. Nobody had told them that a sharp tool nicks the sealing lip and that the leak then shows weeks later at the customer.
The reason turns an order into knowledge. A key point for which nobody can name a reason is removed.
Part of the A3 instruction
| Step | Key point | Reason |
|---|---|---|
| 2 Fit piston seal | Lip faces the pressure side. Slide the seal over the fitting cone. | A reversed lip leaks at once. A tool nicks the lip. |
| 3 Grease seal and tube | One stroke of the dispenser (2 g), full circumference. | A dry spot makes the seal twist on the first stroke. |
| 6 Mount covers and tie rods | Start all four nuts by hand. Tighten in the order 1, 3, 2, 4 to 12 Nm. | Uneven clamping tilts the cover and its seal leaks. |
| 7 Leak test both chambers | 6 bar for 10 seconds per chamber. Hands outside the marked zone. | A shorter test misses slow leaks. The rod extends with 1,870 N. |
Wording rules
- Verb first. Fit, check, tighten, press. Not: the seal is to be fitted.
- Numbers with units. 12 Nm, 6 bar, 10 seconds, 2 g. Never firmly, briefly or enough.
- One name per thing. If step 2 says fitting cone, step 4 does not say mounting aid.
Pictures and symbols
Each step gets one photo, taken at this station from the side of the operator, during real work with real parts. An arrow or a circle shows where to look. A green frame marks the right state, a red frame with a cross the wrong one.
Three fixed symbols stand in front of the key points: one for safety, one for quality, one for ease. They mean the same on every instruction of the plant, so a new operator learns them once.
Header, footer and what stays off the sheet
The header carries identifier, title, station, version, release date, author and approver. The footer lists protective equipment, tools, gauges and materials. Scope, definitions, company policy and the distribution list do not belong on the sheet. They live in the register.
The ten second test
Stand one meter from the sheet and ask an operator for the key point of a step you name. If the answer takes longer than ten seconds, the sheet is too full. If the task does not fit on one sheet with ten steps, it is two tasks.